Dear All,
I would need a professional Diy PSU for the built-in turntable.
Motor AC 120V 15W.
Bearing sintered brass.
Shaft run out
Turntable D Drive
AC 120V motor controller for turntable+Hall+RPM display
- mediatechnology
- Posts: 5719
- Joined: Sat Aug 11, 2007 2:34 pm
- Location: Oak Cliff, Texas
- Contact:
Re: AC 120V motor controller for turntable+Hall+RPM display
Thank you for joining us.
Are you looking for someone to design this for you?
Motor drive is not something we typically discuss here.
Are you looking for someone to design this for you?
Motor drive is not something we typically discuss here.
Woke is dead.
https://ka-electronics.com
https://ka-electronics.com